Set of two universal tie rod ends to fit all CLM lock kits. The rod ends are based on very durable XM uniballs.

The tie rod ends correspond to the dimensions of the original ends of the BMW E46 and can be used interchangeably.

Pin made of very durable 40HM steel.

NOTE: PRE-ORDER PRODUCT. DELIVERY AFTER 24/10/2021

Standard end shown in the picture for comparison only.

Set of 4 retaining sleeves for coilovers / camber plates. If necessary, for an additional fee, the sleeves can be made to any size.

Outer diameter 1: 21 mm (larger)

Outer diameter 2: 18 mm (part going into the bearing)

Inner diameter: 12 mm (the part where the shock absorber enters)

Overall height (end-to-end): 13.5 mm

The height of the larger diameter: 5.5 mm

Height of the smaller diameter: 8 mm

Material: aluminum

Quantity: 4 pieces (set)

Set of spare sleeves for E36 CLM Lock Adapters (4 pcs).

Set of spare sleeves for E46 CLM Lock Adapters (4 pcs).

Lock limiters for CLM adaters are manufactured with the use of CNC method for all lock kits, in particular kits based on CLM lock adapters. The limiters are mounted on the steering rack between the rack and the tie rod with the concave side towards the rack. The lock limiters reduce the maximum steering rack travel and thus the lock angle. The limiters can be successfully used in any car that uses the E36 or E46 steering rack.

CLM subframe wits all E9x and E8x models except 1M and M3 due to different engine mounts. Can be used in 1M and M3 with custom engine mounts.

FRONT HUB

parameters:

Bolt spacing [mm]: 5x 120

Application: front axle

OE number: 31226757024

The set includes 2 front lower arm bolts - a long bolt (internal) and a short bolt (external). We only use Meyle bolt in HD design. This is a set for one lower arm. For one car you need two sets.

Steering stop set made of 6 mm thick stainless steel. Limiters cut with a Fiber type laser, which guarantees the highest accuracy and repeatability of dimensions.

Prepared for the CLM set.

Steering stops made in Poland.

Relocators designed by COELMOTORSPORT made by CNC method, cut out of 8 mm thick steel building sheet.

Relocators made in Poland.